Emerson Epsilon EP Drive 400518-01 Manual de instalación Pagina 155

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 240
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 154
143
Parameter Descriptions
PLS Status
Index.#.PLSStatus
Controlled by the PLSOn and PLSOff Points, this is relative to the distance commanded since the start of the index.
Index.#.PLSStatus will be active if the distance traveled from the start of the index is greater than the Index.#.PLSOnDist and
less than the Index.#.PLSOffDist.
Registration Offset
Index.#.RegistrationOffset
This parameter is the Distance the motor will travel after a valid registration sensor or analog limit value has been detected.
Registration Type
Index.#.RegistrationType
This selects either sensor or analog as the registration mark for a registration index.
Enable Registration Window
Index.#.RegistrationWindowEnable
This check box enables (if checked) the Registration Sensor valid Window. When active, only registration marks that occur
inside the registration window are seen as valid.
Window End
Index.#.RegistrationWindowEnd
This parameter defines the end of the Registration Sensor Valid Window relative to start position of this index. This is an
unsigned value and is relative only to starting position of this index. Index direction does not affect this parameter. The
Registration Window start position is greater than or equal to the Registration point and less than the Registration Window
End position. If a registration sensor is seen outside of this window (not between the WindowStart and WindowEnd
positions) then it will be ignored.
Window Start
Index.#.RegistrationWindowStart
This parameter defines the start of the Registration Sensor Valid Window relative to start position of this index. This is an
unsigned value and is relative only to starting position of this index. Index direction does not affect this parameter. The
Registration Window start position is greater than or equal to the Registration point and less than the Registration Window
End position. If a registration sensor is seen outside of this window (not between the WindowStart and WindowEnd positions)
then it will be ignored.
Registration Sensor
Index.#.SensorTrigger
If registration to Sensor is selected, when this destination activates, motor position is captured and is used as the registration
point for registration type indexes.
Time Base
Index.#.TimeBase
The time base selects either realtime, which allows velocities, acceleration and deceleration to be based on real time, or
synchronized, which allows for an external synchronization signal.
Index Timed Index Enable
Index.#.TimedIndexEnable
This parameter is used in conjunction with the Index.#.IndexTime parameter. If Index.#.TimedIndexEnable is active, then
the programmed Velocity, Acceleration, and Deceleration will be used as maximum values, and the Index Time parameter
will determine how long it takes to perform an index.
Vista de pagina 154
1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 239 240

Comentarios a estos manuales

Sin comentarios