Emerson Epsilon EP Drive 400518-01 Manual de instalación descargar pdf (Pagina 147)

135

Parameter Descriptions

Fault Log - Power Up Count

FaultLog.#.PowerUpCount

This is the module power up count at the time that the fault occurred.

Fault Log - Power Up Time

FaultLog.#.PowerUpTime

This is the module power up time when the fault occurred.

Fault Log - Sub Fault

FaultLog.#.SubFault

The sub-fault value at the time the fault occurred.

Fault Log - Valid Entry

FaultLog.#.ValidEntry

Flag to indicate that the log entry is valid. The flag is cleared for all fault entries when the fault log is cleared.

Module Power Up Count

FaultLog.ModulePowerUpCount

The number of times the module has been powered up.

Enable Feedforwards

FeedforwardsEnable

This parameter may be setup on the Tuning view or through a program, and enables feedforward compensation. When

feedforwards are enabled, the accuracy of the Inertia and Friction settings are very important. If the Inertia setting is larger

than the actual inertia, the result could be a significant overshoot during ramping. If the Inertia setting is smaller than the

actual inertia, following error during ramping will be reduced but not eliminated. If the Friction is greater than the actual

friction, it may result in velocity error or instability. If the Friction setting is less than the actual friction, velocity error will

be reduced, but not eliminated.

Feedhold

When this destination is activated the motor will decelerate to a stop in the time specified by the FeedholdDecelTime

parameter. When it is deactivated the motor will accelerate back up to the programmed speed in the same amount of time.

It is used to hold motion without cancelling the move in progress. If a feedhold is activated during an index the motor will

come to a halt, but the index's velocity command remains at the velocity it was at before the feedhold was activated. When

the feedhold is deactivated time will ramp back up and the index will continue on to its programmed distance or position.

Feedhold affects indexes, homes, and programs. A jog is not affected by the feedhold unless it is initiated from a program.

This is level sensitive.

Feedhold Deceleration Time

FeedholdDecelTime

When Feedhold destination is activated the motor will decelerate to a stop in the time specified by the FeedholdDecelTime

parameter. While the feedhold destination is active, the motion profile is stopped.

2B DevicenetDupMacId

2C TrajectoryFault

2D ProfibusParameterizationFlt

2E ProfibusWatchdogFault

2F ProfibusConfigurationFault

Code FM-3/4

1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 239 240

Comentarios a estos manuales

Sin comentarios

Emerson Epsilon EP Drive 400518-01 Manual de instalación Pagina 147

Comentarios a estos manuales

Relacionado con productos y manuales para Software Emerson Epsilon EP Drive 400518-01