Emerson Epsilon EP Drive 400518-01 Manual de instalación descargar pdf (Pagina 154)

142

Epsilon EP-P Drive and FM-3/4 Module Reference Manual

Distance

Index.#.Dist

This parameter is the Incremental distance that the index will travel or the absolute position for the specified index in user

units. If an index type of Registration is selected, then this is a limit distance, or the maximum distance the index will travel

if a registration sensor is not seen.

Index Time

Index#.IndexTime

This parameter is used in conjunction with the Index.TimeIndexEnable parameter. If TimeIndexEnable is activated, then this

is the time in which an index should complete its programmed distance. The units for this parameter depend on the current

setting of the TimeBase parameter for the specific index. If TimeBase is set to “Realtime” (default), then the units are

Seconds. The user can program the index time with resolution on 0.001 Seconds (or milliseconds). If TimeBase is set to

“Synchronized”, the units defined by the Master Distance Units found on the Master Units view.

Initiate

Index.#.Initiate

The Index.#.Initiate destination is used to initiate the specific index. The Index is initiated on the rising edge of this function.

An Index cannot be initiated if there is an Home, Jog, or Program in progress, or if the Stop destination or if a travel limit is

active. It can be activated from an assignment or from a program.

Limit Distance Hit

Index.#.LimitDistHit

This source is activated when the registration sensor is not found before the Limit Distance is traveled. If the Registration

Window is enabled the sensor must be activated inside the window to be recognized.

Name

Index.#.Name

The user can specify an Index name of up to 12 characters.

Enable PLS

Index.#.PLSEnable

When Activated, this parameter enables the PLS (programmable limit switch) function for the specified index. It can be

controlled from index view check box or from a program.

PLS Off Point

Index.#.PLSOffDist

This an incremental distance from the start of the index to the Index PLS off point. This is an unsigned value and is relative

only to starting position of this index. Index direction does not affect this parameter. Index.#.PLSStatus will be active if the

distance traveled from the start of the index is greater than the Index.#.PLSOnDist and less than the Index.#.PLSOffDist.

PLS On Point

Index.#.PLSOnDist

This an incremental distance from the start of the index to the Index PLS On Point. This is an unsigned value and is relative

only to starting position of this index. Index direction does not affect this parameter. Index.#.PLSStatus will be active if the

distance traveled from the start of the index is greater than the Index.#.PLSOnDist and less than the Index.#.PLSOffDist.

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 239 240

Sin comentarios

Emerson Epsilon EP Drive 400518-01 Manual de instalación Pagina 154