
Revision B.33 2/25/2011
Liebert Monitoring Group – Development
Page 5 of 149
How to use the Reference Library Charts
This document contains a dedicated sheet for each Liebert Unit and associated controller. The title of each chart
contains the name of the Liebert Controller used such as L00 for a Level-0 Air unit or PMP for a Power Monitoring
Panel for Power Center.
Every documented unit assumes the maximum possible optional points and configuratios of the specific unit family.
The specific points that will be used depend on the unit being read as that unit will only report values and alarms
that the specific unit supports.
The first section, Compatible Hardware, indicates the equipment associated with this particular controller as follows:
Indicates the Environmental, Power, UPS or Monitoring Module by model name that
uses this controller.
SiteScan Interface
Modules
Indicates which SiteScan Hardware Modules can be used with the controller. Take
Special note of this box when adding new units to an existing SiteScan system, as
some new controllers are only compatible with the new hardware (SiteLink).
Indicates which SiteScan Hardware Modules can be used with the controller for
interfacing with a third part using BACnet or Modbus protocol.
The next section, Available Points, contains six categories providing the following information:
Status Information for the listed points that will be presented in SiteScan
Alarms that are available to SiteScan
Current settings of controllable Setpoints available to SiteScan
Setpoints that can be changed with SiteScan
Points that can be graphically trended within the SiteScan software
Reports that can be triggered within the SiteScan software
Comentarios a estos manuales