
Reference Manual
00809-0200-4801, Rev CA
July 2010
4-5
Rosemount 3051S
Factory Trim Recall
Method
Sensor Transducer Block
To perform a factory trim on the transmitter, run the Factory Trim Method. If
your system does not support methods, manually configure the Transducer
Block parameters listed below.
1. Set MODE_BLK.TARGET to OOS
2. Set FACTORY_CAL_RECALL to Recall
3. Set SENSOR_CAL_DATE to the current date.
4. Set SENSOR_CAL_WHO to the person responsible for the calibration.
5. Set SENSOR _CAL_LOC to the calibration location.
6. Set SENSOR_CAL_METHOD to Factory Trim
7. Set MODE_BLK.TARGET to AUTO
Comentarios a estos manuales