Emerson FM-3 Manual de instalación descargar pdf (Pagina 137)

123

Parameter Descriptions

Initiate Selector.SelectorInitiate

When this destination is activated, the selector checks the status of all Selector.Select

destinations to determine which Selector.Selection to activate.

ShuntActive

This source is active when the drive's internal shunt is active (conducting current).

ShuntPowerRMS

This parameter models the thermal heating and cooling of the drive internal shunt. This

parameter indicates the percent of shunt capacity utilization and is based on the Heat Sink

RMS value. When this value reaches 100 percent the drive will generate an RMS Shunt

Power Fault. This is only applicable to the EN-208 and EN-214.

Enable Software Travel Limits SoftwareTravelLimitEnable

Software travel limits can be used to limit machine travel. They are often setup inside the

hardware travel limits to add a level of protection from exceeding the machines travel limits.

The SoftwareTravelLimitMinusActive source (output function) is active when the

SoftwareTravelLimitMinusPosn is reached or exceeded. Motion is halted using the

TravelLimitDecel whenever a hardware or software travel limit is hit or exceeded. Software

travel limits are not active unless Absolute Position Valid is active.

Software Travel Limit Minus Activate SoftwareTravelLimitMinusActive

The SoftwareTravelLimitMinusActive source is active when the

SoftwareTravelLimitMinusPosn is reached or exceeded. Motion will come to a stop using the

TravelLimitDecel ramp. Software travel limits are not active unless enabled and Absolute

Position Valid is active.

Software Travel Limit Plus Activate SoftwareTravelLimitMinusPosn

The SoftwareTravelLimitMinusActive source will activate when the

SoftwareTravelLimitMinusPosn is reached or exceeded. Motion will come to a stop using the

TravelLimitDecel. Software travel limits are not active unless enabled and Absolute Position

Valid is active.

Software Travel Limit Plus Active SoftwareTravelLimitPlusActive

The SoftwareTravelLimitPlusActive source is active when the SoftwareTravelLimitPlusPosn

is reached or exceeded. Motion will come to a stop using the TravelLimitDecel ramp.

Software travel limits are not active unless enabled and Absolute Position Valid is active.

1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 229 230

Sin comentarios

Emerson FM-3 Manual de instalación Pagina 137