Emerson FM-3 Manual de instalación descargar pdf (Pagina 125)

111

Parameter Descriptions

deactivate at the start of any deceleration or acceleration. During a synchronized index, this

source could be active even without any motor motion if the master axis stops.

Command Complete Index.#.CommandComplete

The Index.#.CommandComplete source will activate when the specific index completes its

deceleration ramp. It will remain active until the specific index is initiated again. If the Stop

destination is used during an Index, then the Index.#.CommandComplete will not activate.

Command In Progress Index.#.CommandInProgress

The Index.#.CommandInProgress source is active throughout an entire index profile. The

source activates at the beginning of the index acceleration ramp, and deactivates at the end of

the index deceleration ramp.

Decelerating Index.#.Decelerating

This source is active while an index is decelerating from its target velocity. Once the index

reaches zero velocity, or its next target velocity, the Index.#.Decelerating source will

deactivate.

Deceleration Index.#.Decel

This parameter is the Average Deceleration rate used during the index. Units are specified on

the User Units page.

Distance Index.#.Dist

This parameter is the Incremental distance that the index will travel or the absolute position

for the specified index in user units. If an index type of Registration is selected, then this is

a limit distance, or the maximum distance the index will travel if a registration sensor is not

seen.

Initiate Index.#.Initiate

The Index.#.Initiate destination is used to initiate the specific index. The Index is initiated on

the rising edge of this function. An Index cannot be initiated if there is an Home, Jog, or

Program in progress, or if the Stop destination or if a travel limit is active. It can be activated

from an assignment or from a program.

CompoundInitiate Index.#.CompoundInitiate

When activated will initiate the specified Index to compound into the next index in the

program. Only allowed in a program.

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 229 230

Sin comentarios

Emerson FM-3 Manual de instalación Pagina 125