Emerson FM-3 Manual de instalación descargar pdf (Pagina 129)

115

Parameter Descriptions

At Velocity Jog.#.AtVel

This source activates when the particular jog has reached its target velocity. It deactivates

when accelerating or decelerating to another target jog velocity.

Command Complete Jog.#.CommandComplete

The Jog.#.CommandComplete source activates when the specific Jog completes its

deceleration ramp and reaches zero commanded speed. It deactivates when the specific Jog is

initiated again.

Command In Progress Jog.#.CommandInProgress

The Jog.#.CommandInProgress source is high throughout an entire jog profile. The bit goes

high at the start of a jog acceleration ramp, and turns off at the end of a jog deceleration ramp.

Decelerating Jog.#.Decelerating

This source turns on at the beginning of a jog deceleration ramp and turns off at the

completion of the ramp.

Deceleration Jog.#.Decel

This parameter is the average deceleration ramp for the specific jog.

Initiate Minus Jog.#.MinusInitiate

This is used inside a program to initiate a specific jog. When this bit is active, jogging motion

will be initiated in the negative direction at the specified jog velocity.

Initiate Plus Jog.#.PlusInitiate

This is used inside a program to initiate a specific jog. When this bit is active, jogging motion

will be initiated in the positive direction at the specified jog velocity.

Time Base Jog.#.TimeBase

The time base selects either realtime, which allows velocities, acceleration and deceleration

to be based on real time, or synchronized, which allows for an external synchronization

signal.

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 229 230

Sin comentarios

Emerson FM-3 Manual de instalación Pagina 129