Emerson FM-3 Manual de instalación descargar pdf (Pagina 116)

102

FM-3 Programming Module Reference Manual

Drive Ambient Temperature DriveAmbientTemp

This parameter should be set to reflect the ambient air temperature near the drive heatsink

during normal operation. This will determine the amount of regenerative power that can be

dissipated by the E Series drive's internal shunt resistor. When that calculated value is

exceeded by the Shunt Power RMS parameter a shunt fault will occur. Valid only for EN-208

and EN-214 drives.

Drive Analog Output Feedback DriveAnalogOutput.#.Feedback

Displays the Output voltage from one of the two analog outputs found on the 3-pin connector

on the front of the drive or on the drive command connector.

Drive Enable Status DriveEnableStatus

This source is active when the drive is enabled.

Drive Input Debounced DriveInput.#.Debounced

This displays the state of the input after the debounce is taken into account.

Drive Input Debounce Time DriveInput.#.DebounceTime

The Drive Input Debounce Time parameter is the minimum time a digital input must be

steady in order to be recognized by the FM-3. This feature helps prevent false triggering in

applications in electrically noisy environments.

Drive Input Force DriveInput.#.Force

Input can be forced either On or Off. This parameter is the state to which the input will be

forced when the ForceEnable bit is activated.

Drive Input Force Enable DriveInput.#.ForceEnable

If DriveInput.#.ForceEnable parameter is activated, then the state of the DriveInput.#.Force

bit will override the current input state.

Drive Input Name DriveInput.#.Name

This is a text string up to 12 characters that can be assigned to a given input. It allows the user

to use application specific terminology in naming digital inputs.

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 229 230

Sin comentarios

Emerson FM-3 Manual de instalación Pagina 116