Emerson 3051S Especificaciones descargar pdf (Pagina 59)

Reference Manual

00809-0100-4803, Rev DA

Section 3: Configuration

April 2013

Configuration

Note

Both absolute and gage pressure are available as variables. The type of transmitter ordered will

determine which variable is measured and which is calculated based on the user defined

atmospheric pressure. For more information on configuring the atmospheric pressure, see

“Static pressure” on page 59. Since only one of the static pressures is actually being measured,

there is a single damping setting for both variables which may be edited under the Static Pressure

heading.

6. Under the Process Temperature heading, the Units and Damping for the Process

Temperature may be edited.

7. Under the Module Temperature heading, the Units for the sensor module temperature

may be set. The sensor module temperature measurement is taken within the module,

near the differential pressure and/or static pressure sensors and can be used to control

heat tracing or diagnose device overheating.

8. Under the Analog Output heading, the primary variable can be selected from the drop

down menu and the upper and lower range values (4 and 20 mA points) for the primary

variable may be edited.

9. Under the Totalizer heading (Fully Compensated Mass and Energy Flow Feature Board

only), the Totalizer can be configured by clicking on the Configure Totalizer button. This

button allows the user to select the variable to be totalized. The Totalizer Units may also

be edited under this heading.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 187 188

Sin comentarios

Emerson 3051S Especificaciones Pagina 59