Emerson 3051S Especificaciones Pagina 41

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 188
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 40
15
Reference Manual
00809-0100-4803, Rev DA
Section 3: Configuration
April 2013
Configuration
4. The Back button is used to step backward through the flow configuration tabs.
5. The Next button is used to step forward through the flow configuration tabs. The Next
button will not become active until all required fields on the current page are
completed.
6. The Help button may be clicked at any time to get a detailed explanation of the
information required on the current configuration tab.
7. Any configuration information that needs to be entered or reviewed will appear in this
portion of the screen.
8. These menus navigate to the Configure Flow, Basic Setup, Device, Variables,
Calibration, and Save/Send tabs.
9. These buttons navigate to Config/Setup, Device Diagnostics or Process Variables
sections.
3.4.3 Launching engineering assistant
Flow configuration for the 3051S MultiVariable Transmitter is achieved by launching the
Engineering Assistant Software from the START menu. The following steps show how to open
the Engineering Assistant Software, and connect to a device.
1. Select the Start menu > All Programs > Engineering Assistant. Engineering Assistant will
open to screen shown in Figure 3-4 on page 16.
2. If working Offline, click the Offline button located on the bottom of the screen shown in
Figure 3-4.
If working Online, click the Search button located on the lower right hand corner of the
screen shown in Figure 3-4. Engineering Assistant will begin to search for online
devices. When the search is completed, choose the device to communicate with and
click Receive Configuration. See Figure 3-4.
The HART Master Level can be set to either primary or secondary. Secondary is the default and
should be used when the transmitter is on the same segment as another HART communication
device. The COM Port and device address may also be edited as needed.
Vista de pagina 40
1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 187 188

Comentarios a estos manuales

Sin comentarios