Emerson NetSure DCS 48375 Manual de instrucciones Pagina 18

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 44
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 17
UM584622100 Installation and User Instructions
Issue AC, July 3, 2012 Spec. Nos. 584622100, 584622200, 584622300, 584622400 (Model DCS48375)
Page 12 Chapter 3. Setting Jumper and Switch Options
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
CHAPTER 3.
SETTING JUMPER AND SWITCH OPTIONS
JUMPER AND SWITCH SETTINGS ON THE
SYSTEM INTERFACE CIRCUIT CARD
Perform the following procedures to verify the factory settings and/or make the required
settings per your site requirements. These procedures can also be used to make
adjustments on a replacement circuit card.
Refer to Figure 3-1 for switch and jumper locations.
Switch S1
Switch Positions 1 and 2 of S1
Selects the converter system’s output voltage as shown in Table 3-1.
S1
48V
50V
52V
54V
Switch 1
OFF
OFF
ON
ON
Switch 2
OFF
ON
OFF
ON
Table 3-1
Converter System Output Voltage Selection
Switch Position 3 of S1
Selects the current scale for the output current test points as shown in Table 3-2.
S1
1A / 1mV
400A / 50mV
Switch 3
OFF
ON
Table 3-2
Output Current Test Points “Current Scale” Selection
Switch Position 4 of S1
Selects whether converter system output voltage is controlled by the system interface
circuit card (stand alone mode) or by an ACU+ as shown in Table 3-3.
S1
Stand Alone Mode
ACU+ Controller Mode
Switch 4
OFF
ON
Table 3-3
Output Voltage Control Selection
Vista de pagina 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 43 44

Comentarios a estos manuales

Sin comentarios