Emerson Fisher 4320 Manual de instrucciones descargar pdf (Pagina 13)

Instruction Manual

D103621X012

4320 Position Monitor

April 2014

Note

4320 DD's for the Field Communicator are available for download at:

http://www2.emersonprocess.com/en-US/brands/fieldcommunicator/475FC/Pages/SysSoftDDs.aspx

Note that there may be a delay in posting new DD's to this site.

The above link is for the English website. Go to http://www2.emersonprocess.com/Pages/worldwide.aspx to access a specific

country or regional website.

2. Obtain the Network ID and Join Key from the 1420 gateway via web interface. Go to Setup, then select Network. The

Network ID will be shown. Select Yes to see the Join Key.

3. Open the cover of the 4320 and attach the Field Communicator leads to the 4320 HART terminals (see figure 5

or 6).

4. Select Online, Overview, Join Device to Network to enter the network parameter settings (see figure 24 for the

Overview menu tree).

5. Remove the leads from the 4320 and close the cover. Tighten the instrument cover screws to a torque of 5.6

to 6.7 N•m (50 to 60 lbf•in).

6. Install the 4320 on monitored equipment and/or verify the 1420 gateway.

Note

1410 gateway version 4.4.28 or later or 1420 gateway version 4.4.15 or later is required.

Using AMS Wireless Configurator or AMS Device Manager (Using a HART Modem)

1. Verify that AMS has a device description (DD) loaded for the 4320 Device Revision 4 (DD Revision 1 or later).

Note

4320 DD's for AMS are available for download at:

http://www2.emersonprocess.com/en-US/documentation/deviceinstallkits/Pages/deviceinstallkitsearch.aspx

Note that there may be a delay in posting new DD's to this site.

The above link is for the English website. Go to http://www2.emersonprocess.com/Pages/worldwide.aspx to access a specific

country or regional website.

2. Obtain the Network ID and Join Key from the 1420 gateway via web interface.

3. Open the cover of the 4320 and attach the HART modem leads to the HART terminals (see figure 5 or 6).

4. In AMS select the device that is connected to the HART modem.

5. Go to Configure, Guided Setup, Wireless to configure network membership (see figure 7). Select Join Device to

Network enter the network parameter settings.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 67 68

Sin comentarios

Emerson Fisher 4320 Manual de instrucciones Pagina 13