Emerson Rosemount 644h Manual descargar pdf (Pagina 34)

4-6

Rosemount Inc

Savedatafromdeviceto

configuration memory

Prompts user to press SAVE softkey to initiate a device-to-memory

transfer.

Saving data to

configuration memory.

Data is being transferred from a device to configuration memory.

Sending data to device. Data is being transferred from configuration memory to a device.

There are write only

variables which have not

been edited. Please edit

them.

There are write-only variables which have not been set by the user.

These variables should be set or invalid values may be sent to the

device.

There is unsent data.

Send it before shutting

off?

Press YES to send unsent data and turn the HC off. Press NO to

turn the HC off and lose the unsent data.

Too few data bytes

received

Command returns fewer data bytes than expected as determined

by the device description.

Transmitter Fault Device returns a command response indicating a fault with the

connected device.

Units for <variable label>

has changed. Unit must

be sent before editing, or

invalid data will be sent.

The engineering units for this variable have been edited. Send

engineering units to the device before editing this variable.

Unsent data to online

device. SEND or LOSE

data

There is unsent data for a previously connected device which must

be sent or thrown away before connecting to another device.

Use up/down arrows to

change contrast. Press

DONE when done.

Gives direction to change the contrast of the HC display.

Value out of range The user-entered value is either not within the range for the given

type and size of variable or not within the min/max specified by the

device.

<message> occurred

reading/writing <variable

label>

Either a read/write command indicates too few data bytes received,

transmitter fault, invalid response code, invalid response command,

invalid reply data field, or failed pre- or post-read method; or a

response code of any class other than SUCCESS is returned

reading a particular variable.

<variable label> has an

unknown value. Unit must

be sent before editing, or

invalid data will be sent.

A variable related to this variable has been edited. Send related

variable to the device before editing this variable.

Message Description

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 67 68

Comentarios a estos manuales

Sin comentarios

Emerson Rosemount 644h Manual Pagina 34

Comentarios a estos manuales