Emerson E2 Manual del operador descargar pdf (Pagina 12)

3.0 Network Setup

Begin the process by logging on. To do this press the

“USER” in the username field and “PASS” in the pass-

word field. To access the menu shown in figure 3.1:

1. Press menu to open the Main Menu.

2. Press 7 (System Configuration).

3. Press 7 (Network Setup).

4. Press 2 (Connected I/O boards and controllers).

Figure 3.3 Connected I/O Boards and Controllers

Screen

The Intelligent Store™ Discus® devices are listed

under the heading ECT Devices. Use the down arrow

key to highlight the cell next to the ISD-1.0 control.

Enter the number of Intelligent Store™ Discus® com-

pressors that are connected to this E2 (refer to figure

3.3).

3.1 Node Recovery

To begin the node recovery process, proceed as

follows:

1. Access the Controller Setup screen (this can be

done by pressing the “back” button from the

Connected I/O Boards and Controllers screen or

from the main menu by pressing 7 (System

Configuration) followed by 7 (Network Setup)

followed by 3 (Controller Setup).

2. Once the Controller Setup screen has been

accessed it should appear as shown in figure 3.4.

(Note: ISD devices will not be displayed on this

screen unless they have been listed on the

Connected I/O boards and controllers screen as

described in section 3.0 Network Setup)

Figure 3.1 Network Setup Screen Navigation (Key Sequence 7-7-2)

Figure 3.2 ISD Compressor Setup Screen Navigation (Key Sequence 5-35)

AE8-1337 R1

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 70 71

Sin comentarios

Emerson E2 Manual del operador Pagina 12