
Section 5877 User Instructions
Issue AQ, January 15, 2013 Spec. No. 582140000 (Models 802NLDB, 802NLEB and 802NL-B)
Page 2-18 Chapter 2. Navigating the MCA
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
MCA Menu
Tree Line No.
(Section
5886)
TOTAL PCU OUTPUT
aaaaaA
or
TOTAL PCU/RECTIFIER
aaaaaA
Total Rectifier Module (PCU) output current.
Press ENTER to view individual Rectifier
Module load currents.
or
Total Rectifier Module and legacy rectifier
output current when LMS1000 Function
Channel #64 reported value is greater than
zero.
Press ENTER to view individual Rectifier
Module load currents and legacy system
current.
Rectifier Module (PCU) output current. (B#-
ID#/N# = Bay Number-Rectifier Module MCA
ID# w/in Bay/Number of Rectifier Modules in
System).
Press UP and DOWN ARROWS to view other
Rectifier Modules' load currents.
Legacy Rectifier System output current as
reported by the LMS1000 Function Channel
#64.
Press ENTER to go to this menu.
GO BACK TO MENU TREE
BEGINNING
Press ENTER to go to the beginning of the
MCA Menu Tree.
TEMPERATURE SENSOR
ttt C/F
Temperature detected by Temperature Sensor,
if installed.
Press ENTER to go to this menu.
GO BACK TO MENU TREE
BEGINNING
Press ENTER to go to the beginning of the
MCA Menu Tree.
FLOAT MODE IS ACTIVE
SET TEST/EQ?
or
TEST/EQ MODE ACTIVE
SET FLOAT?
or
TEST/EQUALIZE INPUT
IS ACTIVE
or
TURN OFF POWER SHARE
or
TURN OFF ALTERNATE
CURRENT LIMIT
Allows you to change the Rectifier Module
(PCU) output voltage mode.
1. Refer to "Changing a Value or Setting"
in the table at the beginning of this
chapter.
or
The user tried to set Float Mode while an
external test/equalize input signal was being
supplied to the system.
Note: Test/Equalize Mode requires Power
Share and Alternate Current Limit to be turned
off. A message is displayed if Power Share or
Alternate Current Limit is on. Turn Power
Share or Alternate Current Limit off first then
return to this menu.
VIEW THE SYSTEM
INVENTORY
Press ENTER to go to this menu.
Comentarios a estos manuales