Emerson Network Router Manual de usuario descargar pdf (Pagina 38)

32 ProLink

II Software for Micro Motion

Transmitters

Using ProLink II Software

3.8 Viewing meter status

ProLink II allows you to view a variety of status information:

•

Connection LED – located in the lower right corner of the main window (see Figure 3-2).

This LED indicates the status of the connection between ProLink II and the transmitter:

- Green – Good connection

- Red – Connection fault

- Gray – No connection

•

Device Fault Status LED – located in the lower right corner of the main window (see

Figure 3-2). This LED indicates whether or not alarms are active:

- Green – No active alarms

- Red – One or more active alarms

- Gray – Unknown

See Section 3.9 for more information about alarms.

•

Diagnostic Information window – displays sensor diagnostic data

•

Output Levels window – displays current data for the transmitter’s mA, frequency, and

discrete outputs, and also displays discrete event status

•

Status window – displays alarm status. See Section 3.9 for more information about alarms.

•

Alarm Log window – displays alarm status and alarm acknowledgment status. See Section 3.9

for more information about alarms.

•

Core Processor Diagnostics window – displays detailed diagnostic data for the core

processor component

Note: The Core Processor Diagnostics window is read-only. If changes are required, contact

Micro Motion.

•

FingerPrint window – displays detailed information for both process variable data and sensor

diagnostic data

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 95 96

Sin comentarios

Emerson Network Router Manual de usuario Pagina 38