Emerson Network Router Manual de usuario descargar pdf (Pagina 33)

Installation and Use Manual 27

Using ProLink II Software

ProLink II Setup Transmitter StartupUsing ProLink IIBefore You Begin

Figure 3-1 Connect to Densitometer/Viscometer window

Making the connection – all other transmitters

1. Ensure that your PC is connected to a transmitter, using one of the methods described in

Chapter 2.

2. Choose

Connection > Connect to Device. See Figure 3-2.

3. Select the protocol to use. Depending on the

Protocol option that you choose, different

communications options will be available for configuration.

4. Specify

Baud Rate, Parity, Stop Bits, COM Port, and Address/Tag as appropriate for your

connection and transmitter. See Section 2.6 for more information on these parameters.

5. If you are using the USB HART Interface, select

Converter Toggles RTS.

6. Click

Connect.

Alternately, if you do not know the address of your transmitter:

1. Click

Poll. ProLink II will poll the network for all Micro Motion transmitters, and display a

list of all transmitters found.

2. Select the transmitter to connect to, and click

OK.

Figure 3-2 Connection window (all other transmitters)

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 95 96

Sin comentarios

Emerson Network Router Manual de usuario Pagina 33