Emerson ROC364 Manual de usuario descargar pdf (Pagina 21)

Fisher ROC Serial Driver Help

Communications error on '<channel name>' [<error mask>]

COMn does not exist

COMn is in use by another application

Error opening COMn

Unable to set comm parameters on COMn

User-Defined Point Error Messages

Block read for point type '<point type>', logical address '<logical address>', parameter range

'<start parameter - end parameter>' of device '<device name>' failed. Parameters are not in the

loaded UDP configuration

Read for point type '<point type>', logical address '<logical address>', parameter number

'<parameter>' of device '<device name>' failed. Parameter is not in the loaded UDP configuration

Unable to load User-Defined Point configuration for point type <point type>, logical address

<logical address>, parameter number <parameter> of device <device name>. The number of

parameters for this point is 0

Unable to parse the User-Defined Point configuration information for point type '<point type>' on

device '<device name>'

User-Defined Point Configuration upload for point type '<point type>', logical address '<logical

address>', parameter number '<parameter>' of device '<device name>' failed. <Error Reason>

See Also: ROC Error Codes

Error Reasons

For more information on error reasons, refer to the table below.

Error Reason Possible Cause Solution

Device not

responding

* *

Device responded

with error code

The ROC device responded with an error

code.

Framing error The response packet from the ROC device

has data fields that are not as per the

protocol.

This error is very rare. If encountered,

users should check with the

manufacturer to ensure that the ROC

device is consistent with the protocol.

Operator

identification error

The operator identification login (with

User ID and Password) failed.

Refer to the Event Log message that

corresponds to the operator identification

failure.

*For more information, refer to Device '<device name>' is not responding.

**For more information, refer to ROCError Codes.

Address Validation

The following error/warning messages may be generated. The messages are listed here in alphabetical order.

Address Validation

Address '<address>' is out of range for the specified device or register

Data Type '<type>' is not valid for device address '<address>'

Device address '<address>' contains a syntax error

Device address '<address>' is not supported by model '<model name>'

Device address '<address>' is Read Only

Missing address

Address '<address>' is out of range for the specified device or register

Error Type:

Warning

Possible Cause:

A tag address that has been specified statically references a location that is beyond the range of supported

locations for the device.

www. kepware.com

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 38 39

Comentarios a estos manuales

Sin comentarios

Emerson ROC364 Manual de usuario Pagina 21

Comentarios a estos manuales

Relacionado con productos y manuales para Controles remotos Emerson ROC364