
Type 119
2
T
Y
P
E
O
R
I
F
I
C
E
S
I
Z
E
-
I
N
.
S
P
R
I
N
G
R
A
N
G
E
-
P
S
I
MATERIAL
CODE
150 psig (10,3 bar)
See Table 1
150 psig (10,3 bar)
150 psi (10,3 bar) for all port diameter
1. The pressure and temperature limitations in this Instruction Manual, and any applicable code limitation, should not be exceeded.
Figure 2. Type 119 Nameplate
1E5427-F
portion vertical above the body. If installing the
control valve at an outside location, point the
spring case and bonnet vents in the downward
direction to protect them from moisture or
foreign materials.
3. Install the valve using accepted piping practices.
Make sure that the valve is oriented so that ow
through the body will match the ow direction
arrow on the body.
4. If continuous operation is required during
maintenance and inspection, install a three-valve
bypass around the control valve.
5. Connect the control pressure line to the 1/4 NPT
connection in the valve body bonnet marked PILOT.
AI/N
SST/N
SST/V
Aluminum/Nitrile (NBR)
Stainless steel/Nitrile (NBR)
Stainless steel/Fluorocarbon (FKM)
3 to 15
5 to 20
5 to 35
30 to 60
0,21 to 1,0
0,34 to 1,4
0,34 to 2,4
2,1 to 4,1
1D892327022
1D751527022
1D665927022
1D7455T0012
Red
Unpainted
Blue
Green
0.168 (4,27)
0.187 (4,75)
0.218 (5,54)
0.234 (5,94)
2.94 (74,7)
2.81 (71,4)
2.50 (63,5)
2.57 (65,3)
Table 1. Spring Selection
-20° to 180°F (-29° to 82°C)
0° to 250°F (-18° to 121°C)
Not for use with hot water or ammonia.
Up through the seat ring
1/4 NPT internal
6 pounds (3 kg)
Comentarios a estos manuales