Emerson FM-3 Manual de instalación descargar pdf (Pagina 27)

Diagnostics and Troubleshooting

FM-3 Specific Fault Descriptions

Figure 5: FM-3 display is used to display drive and FM-3 faults

Traj Fault

This fault occurs when the drive has received trajectory data from the FM-3 that indicates a

problem. Check the user units, velocities, accels and decels for correct values.

ISR Overrun

This fault is generated when a module flash memory problem occurs. To correct, replace the

FM-3.

OutofSync

This fault is generated when the system is out of sync. To correct it, press the reset button and

check the configuration.

ProgramFault

This fault indicates an FM-3 user program fault. For example the program is attempting to

divide by zero, or overflows and math errors caused by numbers that are too large, or non-

existing parameters.

ProgramInvalid

The user program in flash memory will not run. Download the User Program again using

PowerTools FM-3. A common cause of this problem could be an interrupted configuration

download, such as a cable being disconnected during a download.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 59 60

Sin comentarios

Emerson FM-3 Manual de instalación Pagina 27