Emerson Bristol ControlWave Express Manual de instrucciones descargar pdf (Pagina 36)

ControlWave Express Instruction Manual (CI-ControlWave Express)

2-22 Installation Revised Mar-2011

Pin Description

7 Not connected

8 Not connected

Note: You can swap TX and RX at the hub.

You can connect two nodes in a point-to-point configuration without

using a hub. However, you must configure the cable so that the TX+/-

Data pins connect to the RX+/- Data pins (swapped) at the opposite

ends of the cable (see Figure 2-12).

Figure 2-12. Point-to-Point 10/100Base T Ethernet Cable

The maximum length of one segment (CPU to hub) is 100 meters (328

feet). The use of Category 5 shielded cable is recommended.

2.4 Optional Display/Keypads

The ControlWave Express supports two optional display/keypads and a

display without a keypad:

 A 2-button keypad (shown in the left of Figure 2-13)

 A 25-button keypad (shown in the right Figure 2-13)

 Display only (no keypad) – (see Figure 2-14)

Figure 2-13. Optional 2-Button and 25-Button Keypads

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 87 88

Sin comentarios

Emerson Bristol ControlWave Express Manual de instrucciones Pagina 36