Emerson iPro SERIES Manual de usuario Pagina 135

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 141
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 134
________________________________________________________________________________________________________
1592025400 – Vers. 1.0 - 135
-
If the number of channels is > 1 but the addresses are not consecutive, will be
necessary to define different boards.
This is the situation when your iPRO has to read 3 variables with address 100, 101
and 104; in this case declare two GENAI: the first to read the variables with address
100 and 101 (the Number of Channels = 2), the second to read the variable with
address 104 (Number of Channels = 1).
Then confirm and the new board will be added in your project.
Double click on “Parameters” to configure the GENAI board.
To complete the configuration, confirm with “OK” and save .
Vista de pagina 134

Comentarios a estos manuales

Sin comentarios