Emerson 5-In-One Learning Light-Up Remote Manual de usuario descargar pdf (Pagina 11)

Preparation

Note:

Once you have programmed

SCAN/FAV

for Favor-

ite Channel Scan, you cannot use it for Channel Scan

unless you reset it (see “Resetting Scan”).

1. Select

CBL/SAT

for the favorite channel scan.

2. Hold down

until the red light blinks twice.

3. Press

9 9 6

to start the program.

4. Enter the two-, three- or four-digit number for your

favorite channel.

If you entered less than four digits

, you must do one

of the following: if your original remote requires you

to press Enter or Select to send a command, then

do so after entering the digits of your favorite chan-

nel. If your original remote does not require you to

press Enter or Select to send a command, then after

entering your two- or three-digit channel number,

press

If you entered a four-digit channel number

, do not

press

6. Repeat Steps 4–5 up to nine more times to store

another favorite channel for the same device, or exit

the program by pressing

until the red light blinks

twice.

Note:

Upon entering the 10th channel, the remote

exits the Favorite Channel Programming mode.

Programming Favorite Channel Scan for a second de-

vice deletes the programming for the first.

Resetting Scan

Once you have programmed

SCAN/FAV

for Favorite

Channel Scan, you cannot use it for Channel Scan un-

less you reset it.

To reset

SCAN/FAV

, follow these steps.

1. Select either

CBL/SAT

2. Hold down

until the red light blinks twice.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

Comentarios a estos manuales

Sin comentarios

Emerson 5-In-One Learning Light-Up Remote Manual de usuario Pagina 11

Comentarios a estos manuales