Emerson ControlWave MICRO Manual de instrucciones descargar pdf (Pagina 118)

ControlWave Micro Instruction Manual (CI-ControlWave Micro)

3-64 I/O Modules Revised Jun-2013

Figure 2-38. IEC62591 Module – Connecting Termination Jumpers

Software Configuration

After you configure a wireless network for your devices, you need to

configure your ControlWave project to access the interface module,

and through it, the wireless network.

To do this, you either need to modify the IEC62591 example program

in ControlWave Designer to meet the needs of your application, or you

need to copy all the POUs, structures and variables associated with the

example program into an existing project.

In your ControlWave project you must specify the network ID and join

key for the network, which are parameters to the IEC62591 function

block. You also need to specify the long tag name associated with each

wireless device and set its flag for commissioning. In addition you

must specify structure sizes based on the maximum number of wireless

devices to include in your network.

See Chapter 3 of the ControlWave IEC62591 Wireless Interface

Instruction Manual for information on modifying the IEC62591

example program.

For detailed information on configuring the IEC62591 function block,

which is used in the example program, refer to the online help within

ControlWave Designer.

Termination Jumpers

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 169 170

Sin comentarios

Emerson ControlWave MICRO Manual de instrucciones Pagina 118